 |
ATTENTIONThis FlexSim Community Forum is read-only. Please post any new questions, ideas, or discussions to our new community (we call it Answers) at https://answers.flexsim.com/. Our new Question & Answer site brings a modern, mobile-friendly interface and more focus on getting answers quickly. There are a few differences between how our new Q&A community works vs. a classic, threaded-conversation-style forum like the one below, so be sure to read our Answers Best Practices. |
 flexsim.com |
|
||||||
| Downloads |
| Tips and Tricks Share helpful modeling ideas |
|
#1
12-27-2014
|
||||
|
||||
Pointer to an object based on Coordinate location
Dear Community Members,
The attached is a sample model which shows, pointer to an object based on it's coordinate location.I have created a user command named upobject(x,y,z) for pointing.The coordinate values are entered in the global table. The pointer to a queue is shown in this model using the user command .Check the task sequence inside queue and user command upobject to know how it is implemented. Please give your suggestions and corrections to this model. Wishing you a Happy New Year. Regards, Arun KR |
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unloading an item or operator from elevator to specific coordinate | Christian Norregaard | Q&A | 2 | 10-05-2012 12:42 AM |
| Question about coordinate system in Flexsim. | Robert Liu | Q&A | 3 | 07-15-2011 08:10 PM |
| each item has it's given location,and item's code correspond to storage location | Robert Liu | Q&A | 3 | 03-28-2011 08:46 PM |
| Storing a C++ class pointer in a flexsim object | Steven Hamoen | Q&A | 2 | 04-15-2010 09:19 AM |
| coordinate axis | juan alberto | Q&A | 1 | 11-24-2009 03:03 AM |
